Hondaclub-belgium.be

JFK78 schreef:Plenty of people have done the D2B before without an adapter plate, with various small differences in execution. The D2B is a very important part of this build, so I tried to document how we did it well. We also had several vital components made to help others do this safely and with relative ease. The following stock B-series parts are used:

shift linkage
rear t-bracket
tranny mount and rear mount
starter
intermediate shaft
axles
clutch

We had Competition Clutch make B-series flywheels that are drilled for D-series cranks. They now have this available as Part no: 2-694D-ST

With this you can use any standard B-series clutch!

I really needed a twin disc for this build though, and once again Competition Clutch came through with a B-series twin disc kit w/the flywheel drilled for a D-series crank as well! This is available as Part no: 4-8026-D

Here's some pics/explanation of how we did it and what it takes to bolt the engine to the tranny. More to come later.













Doing the D2B like this shifts the engine 1" closer to the passenger side of the engine bay. So we had this custom billet drivers side engine mount designed to make up for that.





About ready to drop in, just waiting on mounts and injectors. Shot a few different angles to help show the D2B.

We also have the billet block-to-tranny braces and intermediate shaft pillow block being made, just not finished yet.

jonas (R-garage) schreef:dan gaat ge uw D-series blokjes hard mogen tunen Nick om zo de aandrijfing rond te krijgen !

jonas (R-garage) schreef:dan gaat ge uw D-series blokjes hard mogen tunen Nick om zo de aandrijfing rond te krijgen !

integradical schreef:b16's ja